Motion Controlled Light

    Motion detection will turn on a light if the room is dimmer than a certain level. That level will be set using a variable so it is easy to change.  Tab ‐ System Design Select device ‐ Motion Sensor Set property ‐ Occupancy Hold Time ‐ 10 mins. Light will turn off after there has been no motion for 10 […]

    Read More

    How To Control Garage Doors

    Our wall plug or POE powered, ZigBee repeater, the ‘Relay & Contact Sensor’ can control up to 3 garage doors. See our step by step guide for detailed instructions on these topics: Physical relay connections to garage controller Viewing garage door open/close state in Control4 Navigator Operating garage doors using Control4 Navigator Operating garage doors […]

    Read More

    Display Temperature on Control4 Navigator

    Our devices that measure temperature have a connection for it in Control4 Composer. Bind it to our temperature display driver to show it on the Control4 Navigator. Step by step guide: How To Display Temperature On Control 4 Navigator.pdf

    Read More

    Joining a Device to the Control4 Network

    To download drivers Network Button Commands These reports will also run on boot up. 15 tap the network button or remove and re-apply power to make the device report its network status. Troubleshooting Success then fail If successful join is reported then failed to join is reported right after, it means it started to join […]

    Read More